畅享聊:SolidWorks学习(29)（solidworks基础入门教程视频）

分享兴趣，传播快乐，增长见闻，留下美好！

亲爱的您，这里是LearningYard新学苑。

今天小编为你带来

畅享聊：SolidWorks学习（29）

欢迎您的访问！

Share interests, spread happiness, increase knowledge, and leave beautiful!

Dear you, this is LearningYard Academy.

Today, the editor brings you

Changxiang Chat:SolidWorks Learning (29)

welcome your visit!

今天我们一起来画基座以及夹头板a和b，零件图都已在下方了，由一个俯视图和一个A-A剖视图组成。可以看出基座还是比较简单的，孔洞也不多，需要注意的是这里有反面沉孔，注意不要忘记了。还有就是四个M3是螺纹孔。

Today we will draw the base and clamp plates a and b together. The part drawings are below, consisting of a top view and an A-A sectional view. It can be seen that the base is relatively simple and there are not many holes. It should be noted that there are reverse counterholes here, so don't forget. Also, the four M3 are threaded holes.

画完基座后接着画夹头板a和b，这两个板子看起来差不多，整体的尺寸大小也是一样的,。厚度也都为2，a板相对复杂一点，有一个矩形孔，a板的矩形孔这里定位数据并没有给完善，我们合理安排就好。这里有4个M2的螺纹孔，以及一个M3的螺纹孔。我们只需要耐心一步步建模就行。

After drawing the base, proceed to draw clamp plates a and b. These two plates look similar and have the same overall size,. The thickness is also 2, and the A board is relatively more complex with a rectangular hole. The positioning data for the rectangular hole on the A board is not complete, so we can arrange it reasonably. There are four M2 threaded holes and one M3 threaded hole here. We just need to be patient and model step by step.

今天的分享就到这里了。

如果您对今天的文章有独特的想法，

欢迎给我们留言，

让我们相约明天，

祝您今天过得开心快乐！

That's it for today's sharing.

If you have a unique idea about today’s article,

Welcome to leave us a message,

Let us meet tomorrow,

I wish you a nice day today!

本文由learningyard新学苑原创，如有侵权，请联系我们。

部分内容参考于bilibili，百度

翻译来源：通义千问

文字排版｜calm

审核｜DongYang